General Motors has decided that a safety defect affecting airbags exists in certain 2010-2015 and 2017 Buick Enclave, 2010-2019 Chevrolet Traverse and 2011-2016 GMC Acadia vehicles.

According to the defect report, in October 2020, a third-party vehicle repair business contacted GM requesting repair assistance on a 2018 Buick Enclave. After removing the headliner to attempt to repair a sunroof water leak, the repair shop identified two fasteners that were not installed and one missing weld nut attaching the roof-rail airbag (RRAB) to the vehicle. Further investigation found that certain stampings associated with the connection of the roof rail airbag to the vehicles had damaged, out of position or missing weld nuts. Although the problem was identified during vehicle assembly, the repairs may have been missed or preformed incorrectly.

GM will notify owners, and dealers will inspect and, if necessary, realign or replace the weld nuts GM’s number for this recall is N202321200 and the NHTSA campaign number is 21V246.

Chrysler has announced that certain 2014-2015 RAM 1500 Quad Cab trucks may not comply with the requirements of Federal Motor Vehicle Safety Standards (FMVSS) for airbag safety. According to reports, the affected vehicles are equipped with side air bag inflatable curtains (SABIC) that may not fully overlap the C-pillars. In the event of an accident, the SABIC may not inflate as intended, increasing the risk of injury to the rear seat occupant.

Certain 2011-2014 Hyundai Tucson vehicle may be affected by a manufacturing problem that could lead to the drivers side airbag inadvertently deploying or not deploy at all during an accident.

According to reports filed with the NHTSA, during assembly, it is possible that the bolts attaching the driver’s airbag module to the steering wheel assembly were not properly torqued. Over time, the bolts could loosen causing a rattling noise and could eventually detach from the steering wheel completely. There have been no reports of accidents or injury because of the problem. Continue reading

Hyundai is recalling certain 2007-2009 Santa Fe and 2012-2013 Sonata vehicles because of airbag problems that could increase the risk of injury to vehicle occupants.

  • Approximately 220, 000 Santa Fe vehicles manufactured between April 2006 to July 2008, could have an improperly calibrated occupant classification system (OCS). The problem could lead to the airbags not deploying during an accident increasing the chance if injury. Owners will be notified to bring in their vehicles to get the OCS software updated.
  • Approximately 22, 000 Sonata vehicles manufactured between January to June, 2012 are being recalled because the curtain airbag may inflate without a deployment command. The manufacturing error could increase the risk of injury to the occupants and could increase the chance of an accident by distracting the driver.

Owners wanting more information on either recall can contact Hyundai customer services at 1-800-633-5151.

A recent recall on certain 2012 Honda Accord and Crosstour vehicles has been expanded to include an additional 627 vehicles. The recall is over driver and passenger side curtain airbag inflators that were not manufactured according to manufacturers specifications. In the event of an accident, the side curtain airbags may fail to deploy, leaving the occupants unprotected. Honda will inspect and replace the driver’s and passenger’s side curtain airbags as required. Owners wanting more information on the problem can contact Honda at 1-800-999-1009. The vehicles included in the recall include: