Certain 2015 Cadillac Escalade and Escalade ESV SUVs could fail to conform to the Federal Motor Vehicle Standard (FMVSS) for occupant crash protection. According to reports filed on the NHTSA website, the passenger side instrument panel top cover may have been manufactured with inadequate adhesion between the spacer fabric and the vinyl show surface. The problem could result in the airbag not deploying consistently, increasing the chance of injury to the front passenger. Continue reading
Category Archives: General Motors
2015 Chevrolet Corvette Safety Defects
General Motors has announced two safety defects involving certain 2015 Chevrolet Corvette sports cars. They will be asking owners to return to a manufacturer approved repair facility to have the problems fixed. Both problems are due to manufacturing errors. The first affects the drivers side airbag and the second, the parking brake. Continue reading
Takata Airbag Defect Affects Many Manufacturers
The National Highway Traffic Safety Administration (NHTSA) is urging owners of certain BMW, Chrysler, Ford, General Motors, Honda, Mazda, Mitsubishi, Nissan, Subaru, and Toyota vehicles to take immediate action and replace defective Takata airbags. Vehicle owners receiving regional recalls are especially urged to get the problem taken care of, as consistent hot and humid conditions are suspect to intensify the problem. These areas include: Florida, Puerto Rico, areas in Texas near the Gulf of Mexico, Alabama, Mississippi, Georgia, Louisiana, Guam, as well as Guam, Saipan, American Samoa, Virgin Islands and Hawaii. Continue reading
GM Chassis Electronic Module Short
General Motors have identified a defect relating to motor vehicle safety exists in certain Buick, Cadillac, Chevrolet, and GMC cars, trucks, minivans, and SUVs, after certain vehicles began displaying a check engine malfunction indicator lamp (MIL) during post production testing. After observing an increase in warranty claims, GM has decided to issue a recall to have the problem repaired. Continue reading
2010 Chevrolet Traverse Buyback For Steering Defects
When the Law Offices of Delsack & Associates, P.C. were contacted by a California resident experiencing steering problems with his 2010 Chevrolet Traverse, we were not surprised to see that the SUV had five (5) technical service bulletin’s issued for the steering system. The owner said he purchased the Traverse in June, 2010, and by August, 2011 already had four (4) unsuccessful repair attempts by a GMC dealer. According to service reports, repairs included replacement of several parts in the rack & pinion system, as well as replacement of the power steering pump. Continue reading
2010 Cadillac SRX Repurchased Under California Lemon Law
Approximately two months after purchasing his new 2010 Cadillac SRX, the vehicle owner had already returned his truck to a GMC dealership for its first repair attempt. He subsequently provided GMC fifteen (15) more opportunities to repair the defect before he decided to contact the Law Offices of Delsack & Associates, P.C. to demand the repurchase of his vehicle under the California Lemon Law. Continue reading
Buick, Cadillac, And Chevrolet Sedan Steering Problem
General Motors will be asking owners of certain Buick, Cadillac, and Chevrolet sedans to return their vehicles to a manufacturer approved repair facility to have their vehicles steering system inspected and repaired. According to reports filed at the NHTSA website, the fasteners holding the intermediate shaft and the steering gear, and/or at the lower control arm to the lower ball joint may have not been torqued to the correct specifications. The fasteners could loosen, parts could separate, and the driver could experience complete loss of steering. Continue reading
General Motors Seat Problem
General Motors will be asking owners of certain Buick, Cadillac, Chevrolet, and GMC vehicles to return to their dealership to repair a problem that could leave the front seat occupant unprotected during an accident.
Some vehicles may have been manufactured with an incomplete weld on the seat hook bracket assembly for both front seats. If the assembly is exposed to a high load condition, the hook could separate from the seat track, increasing the risk of injury to occupants. Continue reading
