Category Archives: Ford

News about Ford automobile manufacturer. News about Ford recalls, technical service bulletins (TSB), and problems regarding Ford vehicles.

2019 Ford F-250 And F-350 – Steering Pulls To The Left Or Right

Posted on by

Ford Motor Company will be contacting the owners of certain 2019 F-250 and F-350, single rear wheel and dual rear wheel 4X4 trucks, because the front axle could have a problem which makes it difficult to control the vehicle.

According to the defect report, the affected vehicles may have been manufactured with front axles with a wheel end yoke that was not properly welded to the axle tube end. An improperly welded axle yoke attachment could affect vehicle control, including:

1. pulling to the right or left
2. mis-alignment of the steering wheel
3. change in steering sensitivity
4. vehicle response time during hard braking

During a hard braking event, drivers may experience a loud popping noise from the front axle before vehicle control is affected.

Owners receiving notices will be instructed to return to their Ford or Lincoln dealer to have the front axle wheel yoke weld location inspected. If the weld is in the wrong place, the axle assembly will be replaced. Ford’s number for this recall is 20S56 and the NHTSA campaign number is 20V-576 .

Ford Explorer And Lincoln Aviator Airbag Deployment Problem

Posted on by

Ford have identified a problem affecting the seat back side airbags in a small number of 2020 Ford Explorer and 2020 Lincoln Aviator vehicles.

According to the defect report, the front seat back sub-assemblies may have been placed in the wrong work in progress rack after a machine interruption. Some of the DC runner nuts may have not been torqued, leaving the air bag and seat back module not fully secured. The problem could delay the positioning of the air bag cushioning and the deployment of the airbag could be affected.

Owners receiving notices will be asked to return their their Ford or Lincoln dealer so that they can verify that the fasteners have been properly tightened. Ford’s number for this recall is 20S48 and the NHTSA campaign number is 20V-497.

2020 Ford F-150 Grinding Noise When Engine Starts

Posted on by

Ford will be contacting a small number of 2020 Ford F-150 owners because of a problem with the electrical system in their trucks. According to the safety report filed with the NHTSA, the affected vehicles were built at their Kansas City assembly plant June 30, 2020 and July 1, 2020.

These trucks may have been built with a positive power supply cable nut that does not meet design specifications. These nuts do not have the correct torque characteristics or conductive coating needed at the power supply attachment to the starter motor. This could increase the amount of heat generated during starting and could create an electrical arch that could start a fire. Drivers will be alerted of a problem through grinding noises when starting or restarting during a stop-start event, or the engine may not start at all.

Owners receiving notices will be asked to return to their dealers to have the starter motor B+ power supply attachment nut replaced with the correct part. Ford’s number for this recall is 20S40 and the NHTSA campaign number is 20V-467.

Lincoln MKX And Lincoln Nautilus Seat Wiring Damage

Posted on by

Ford Motor Company will be asking the owners of certain 2016-2018 Lincoln MKX and 2019-2020 Lincoln Nautilus SUVs, to return to their dealership to fix a wiring problem that could affect the air bags. These vehicles are equipped with 16 way electric tilt seats.

According to the safety report, the seats in these vehicles may have a wiring harness that was not properly protected from the edge of the seat cushion frame. When the tilt function is used, it is possible that the wires could become damaged and, as a result, the airbag system may not function as intended.

Ford is not aware of any accidents or injuries related to this problem, but they will be asking owners to return to their dealerships to have the wire harness inspected and replaced as necessary. Also, a protective flocking tape will be installed onto the exposed edge of the 16-way seat cushion frames. Ford’s number for this recall is 20S37 and the NHTSA campaign number is 20V-414.

Expedition & Navigator Called Back For Improperly Welded Headrests

Posted on by

Concerns related to improperly welded second row headrest attachment brackets will have some 2020 Ford Expedition and 2020 Lincoln Navigator vehicles recalled for repairs. Dealers are required to inspect and repair the problem before demonstrating or delivering any new stock.

According to the defect report, an in plant inspection found that the headrest to seat back frame attachment bracket was out of position during assembly and some welds did not properly penetrate the headrest bracket. As a result, the strength of the headrests are weakened and they do not meet the Federal Motor Vehicle Safety Standards for head restraints. An improperly welded headrest bracket may not adequately restrain an occupant during a crash.

Those receiving notices will be asked to return to their dealership to have the seat structure inspected and replaced as needed. Ford’s number for this recall is 20C12 and the NHTSA campaign number is 20V-366.

2020 Ford Mustang Collision Avoidance Problem

Posted on by

Ford will be contacting a small number of 2020 Mustang owners because of a problem affecting the collision avoidance system in their cars. These vehicles are equipped with a forward looking camera that may not function as intended.

According to the defect report, the affected vehicles have an image processing module, or a forward looking camera that was misaligned during assembly. This incorrect calibration may cause features such as pre-collision assist, adaptive cruise control, lane keeping system, driver alert and auto high beam control to not work as intended. The pre-collision assist system’s effectiveness to detect a frontal collision may be compromised, increasing the risk of an accident and injury.

Those receiving notices will be asked to return to their dealers to have a lane departure warning system camera alignment procedure done. Ford’s number for this recall is 20S26 and the NHTSA campaign number is 20V-306.

Ford Pre-Collision Assist Will Not Enable

Posted on by

Ford had decided that a problem affecting the collision avoidance system exists in certain 2020 Ford Expedition and 2020 Lincoln Navigator vehicles. The condition affects models equipped with the standard camera-only pre-collision assist built within a certain time period. Vehicles with optional radar plus camera pre-collision assist systems are not affected.

According to the defect report, the affected vehicles are equipped with pre-collision assist features that are not functional. This includes: Forward Collision Warning, Dynamic Brake Support and Automatic Emergency Braking. There is no warning to the driver that these features are not functional, increasing the risk and severity of a frontal collision.

Dealers will correct the problem by reprogramming the software affecting the Body Control Module, Anti-lock Braking System, Instrument Panel Cluster, Headlamp Control Modules and reset the Tire Pressure Monitor System. Ford’s number for this recall is 20S20 and the NHTSA campaign number is 20V-262.

Inaccurate Transmission Indication

Posted on by

Ford has determined that a potential safety defect exist in certain 2020 Ford Expedition, F-150, and Ranger trucks equipped with 10 speed automatic transmissions.

According to the defect report, some vehicles may have been manufactured with a gear shift cable lock that may not be fully seated. The partially seated clip could allow the transmission to slip and show a different gear than the transmission is in. This could result in “shifter mismatch”, “shifter inoperative”, “shifter stuck in park” or “no start” symptoms. Drivers may be able to shift into “Park” and remove the key while the transmission may not actually be in “Park”. The instrument panel display will continue to show the correct transmission gear state.

Owners receiving notices will be asked to return to their Ford dealerships to have the shifting lock clip inspected and replaced as necessary. Ford’s number for this recall is 20S18 and the NHTSA campaign number is 20V-197.